Amplifier Separate Type Photoelectric SensorPS-N series


Amplifier Unit, Cable Type, Main Unit, NPN


Select Language







Main unit/Expansion unit

Main unit


Control outputs

1 output

External input

1 input

Response time

500 μs (TURBO)/1 ms (SUPER)/4 ms (ULTRA)/16 ms (MEGA)

Output selection

LIGHT-ON/DARK-ON (switch-selectable)

Timer function

Timer OFF/OFF-delay timer/ON-delay timer/One-shot timer, Timer duration selectable: 1 ms to 9999 ms, Maximum error against the setting value: ±10% max.

Control output

NPN open collector 30 V, (without expansion) 100 mA max., (with expansion) 20 mA max,
residual voltage 1 V max. (when the out current is 10 mA or less)/2 V max. (when the output current is 10 to 100 mA)

External input

Input time 2 ms (ON)/20 ms (OFF) or more*1

Unit expansion

Up to 17 main units can be connected

Protection circuit

Reverse polarity protection, Over-current protection, Surge absorber

Number of interference prevention units

4 for TURBO/SUPER/ULTRA/MEGA (When set to DOUBLE, the number of interference-prevention units will be doubled)

Case size

H 32.6 mm 1.28"× W 9.8 mm 0.39" × L 78.7 mm 3.1"


Power voltage

24 VDC (operating voltage 10-30 VDC (with ripple)), ripple (P-P) 10% or less, Class 2 or LPS

Power consumption

Normal: 810 mW or less (at 30V. 28 mA max. at 24 V, 34 mA max. at 12 V)
Eco on mode: 700 mW or less (at 30V. 24 mA max. at 24 V, 27 mA max. at 12 V) Eco Full mode: 490 mW or less (at 30V. 17 mA max. at 24 V, 20 mA max. at 12 V)

Environmental resistance

Operating temperature range

-20°C to +55°C -4°F to 131°F (No freezing)*2

Operating ambient humidity

35 to 85% RH (No condensation)


10 to 55 Hz, double amplitude: 1.5 mm 0.06", 2 hours each in the X, Y and Z axis

Shock resistance

500 m/s2 3 times for each of X,Y and Z axis



Main unit and cover material: Polycarbonate




Approx 75 g

*1 Input time is 25 ms (ON)/25 ms (OFF) when the external calibration time is selected.
*2 If more than one unit is used together, the ambient temperature varies with the conditions below. Mount the units on the DIN rail with mounting brackets and check that the output
current is 20 mA or less for a uni t .
One or two more units connected: -20°C to +55°C -4°F to 131°F; 3 to 10 more units connected: -20°C to +50°C -4°F to 122°F; 11 to 16 more units connected: -20°C to +45°C -4°F to 113°F.

  • For Beginners Sensor Basics Understanding fundamental - Introduction Guide to Sensors

Latest / Most Downloaded

    • General Catalog Request
    • Trade Shows and Exhibitions
    • eNews Subscribe