The Easiest, Most Intuitive, Step-by-Step Scanner Configuration Software You Will Ever Use
For the ultimate in ease of use, simply mount the SZ in the desired
clear the area, and click the "Automatic Drawing" tool. Immediately the SZ draws a zone around existing obstacles.
Unlike conventional scanners which use a single set of safety signals (OSSD1,2) requiring external input signals to toggle between protection zones, the SZ-04M features true simultaneous protection of two independent zones. No switching is required since two sets of safety signals (OSSD1,2 and OSSD3,4) are provided.
This function can send a signal to a PLC or other non-safety device for the intent of displaying real-time status information on an HMI or other interface. For example "Lens is soiled, please wipe clean,then reset" or "EDM Error. Please check external devices".
Rectangular zones can be configured without a PC through the information display. Configuration is easy and it is no longer necessary to bring a PC for on-site operation.
This function temporarily overrides safety functions during the robot's "teach" mode. It can only be activated when the SZ receives the teach mode signal from the robot.
The SZ Series has two scanning cycles, which makes it possible to
reduce mutual interference between the SZs
Regardless of the OSSD output type (NPN, PNP) being used, all non-safety outputs can be wired for either NPN or PNP operation depending on input device polarity.