Recent Searches
    Series ( results)
      Models ( results)

          RGB Digital Fiberoptic SensorsCZ-V20 series


          Amplifier Unit, Main Unit, PNP

          [Discontinued model]

          This model has been discontinued.

          Recommended Replaceable Products
          To contact us:


          Select Language




          PNP output

          Main unit/expansion unit

          Main unit

          Response time

          8 ms (SUPER) /4 ms (TURBO) /1 ms (FINE) /200 µs (HIGH SPEED)

          Control output

          PNP open-collector x 4 channels, 30 VDC max., Up to 100 mA for one output, Up to 200 mA in total of 4 outputs, Residual voltage: 1.0 V max.*1

          Protection circuit

          Reverse-polarity protection, overcurrent protection, surge absorber

          External calibration input

          No-voltage input, input time: 20 ms or more

          External shift input

          Timer function

          Timer OFF/OFF-delay/ON-delay/One-shot, Timer time: 1 to 1000 ms adjustable (for each bank respectively)

          Unit expansion

          Up to 3 units (4 units total including the main unit)*2


          Power voltage

          24 VDC, Ripple (P-P) 10 % or less

          Power consumption

          Normal mode: 1.5 W (62.5 mA or less), Eco-mode: 1 W (42.0 mA or less)

          Environmental resistance

          Ambient temperature

          -10 to +55 °C 14 to 131 °F (No freezing)*3

          Vibration resistance

          10 to 55 Hz, Double amplitude 1.5 mm 0.06", 2 hours in each of the X, Y, and Z axis


          Housing, cover: Polycarbonate


          Approx. 110 g

          *1 20 mA max. when several units are connected.
          *2 The FS-V20 Series expansion unit cannot be connected to the CZ-V20 Series main unit. When using a combination of expansion units, connect the CZ-V20 Series expansion unit to the FS-V20 Series main unit. Also, if using multiple expansion units, make sure to connect the CZ-V20 Series to right side of the FS-V20 Series.
          *3 When several units are connected, the acceptable ambient temperature varies depending on the conditions given below. To connect several units, be sure to mount them to a DIN rail and to limit the output current to a maximum of 20 mA.
          When 1 or 2 units are connected: -10 to +50 °C 14 to 122 °F
          When 3 units are connected: -10 to +45 °C 14 to 113 °F

          • General Catalog Request
          • Trade Shows and Exhibitions
          • eNews Subscribe