Specs Compact Nozzle Static Eliminator SJ-LM series

Model		SJ-L005M	SJ-L005MT
Image
Type		Nozzle type	Tube type
Voltage application method		High frequency AC method	High frequency AC method (68 kHz)
Applied voltage		2.2 kVAC	2.5 kVAC
Ion balance		±10 V^*1	±10 V^*6
Static elimination time		0.4 sec.^*1	See Data Sheet.
Air supply pressure		0.05 to 0.5 MPa
Air supply temperature		0 to +50°C 32 to 122°F
Connection tube		Outer diameter: ø6 0.24", inner diameter: ø4 0.16"
Ozone concentration		0.05 ppm or less^*2	0.05 ppm or less^*7
Control input	Static elimination stop input	Switchable between non-voltage input and voltage input Non-voltage input: ON voltage 2 V or lower, OFF current 0.1 mA or lower, ON current 2 mA or lower (short circuit) Voltage input: Maximum input rating 30 V, ON voltage 7 V or higher, OFF current 0.1 mA or lower, ON current 1.5 mA or lower (at 30 V)^*3
	Reset input
	LPC mode input
Control output	Alarm (N.C.)/Ion level alarm (N.O.)	Open-collector output 30 VDC or less 50 mA max., residual voltage 1.5 V or less NPN/PNP settings switchable^3^4
Ratings	Power voltage	24 VDC ±10% (including ripple) or 12 VDC (dedicated AC adapter OP-88020/87722^*5)
	Current consumption	0.2 A or less (24 VDC) 0.3 A or less (12 VDC)
Environmental resistance	Ambient temperature	0 to +50°C 32 to 122°F (0 to +40°C 32 to 104°F when OP-87722 is used)
	Relative humidity	35 to 65% RH (no condensation)
	Overvoltage category	I
	Pollution degree	2
Material		Main unit case: PBT / Charge indicator: TPU / Securing bracket: SUS303, PBT Cable: PVC, TPE, copper alloy Connector: PBT, brass + gold plating, phosphor bronze + gold plating, coper alloy + gold plating Fitting: Brass + electroless Ni plating, POM, NBR
Weight		Approx. 60 g	Approx. 65 g
^1 Measurement results taken with an installation distance of 150 mm 5.91", air supply pressure of 0.2 MPa, and a nozzle angle of 90° (typical values) ^2 Measurement results taken with an installation distance of 100 mm 3.94", air supply pressure of 0.1 MPa, and a nozzle angle of 90° (typical values) ^3 Cannot be used when the power supply is the AC adapter. ^4 To use the ion level alarm with the tube type, use it with air supply pressure of 0.3 MPa or less. ^5 Rated input of 100 to 240 VAC, 50/60 Hz ^6 Measurement results taken with tube length of 500 mm 19.69", an installation distance of 50 mm 1.97", and air supply pressure of 0.2 MPa (typical values) ^*7 Measurement results taken with tube length of 500 mm 19.69", an installation distance of 300 mm 11.81", and air supply pressure of 0.1 MPa (typical values)